Draft 2 of NSF/ANSI 50 issue 87 is being forwarded to the Joint Committee for balloting. Please review the changes proposed to this standard and submit your ballot by August 8, 2013 via the NSF Online Workspace. THIS IS A 2-WEEK BALLOT.
Purpose
The purpose of this ballot is to replace the current repeatability variance for each output measurement to a 10% limit on the average of the 5 repeatability measurements at both 50% and 100% output.
Revision 2 addresses comments received from the revision 1 ballot on how to calculate the variance of each output rate from the average output rate for the 50% and 100% tests. This two-week adjudication ballot also addresses one unresolved negative comment that was received stating the calculation was not clear; revision 2 addresses the comment; however the commenter did not accept the response.
This ballot allows voters the opportunity to change or reaffirm their vote based on the content of the comments contained herein.
Voting options:
1. Affirmative: you are voting to accept the ballot document as it stands after your consideration of the unresolved negative comments.
2. Negative: You are voting to reject the ballot document as it stands after your consideration of the unresolved negative comments. Voters who change an affirmative to a negative shall cite the unresolved negative comment that caused their decision.
3. Abstain: You do not feel that you have sufficient information to make an informed decision on this issue.
Please note that if you do not return a vote in this adjudication ballot, your original vote will remain in effect.
At the close of this adjudication ballot, all results will be tallied to determine if the requirements for consensus have been satisfied. |
